ION GENERATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ion generator sub-assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system (for Mono camera type)

for Stereo Camera type: Click here

for Mono Camera type: Click here

Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Mono camera type)
Pre-collision system (for Stereo camera type)
Adaptive high beam system

    Lighting system (EXT)

  • cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

Steering sensor (Including removal and installation) Steering angle neutral point Parking support brake system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Steering angle setting Parking assist monitor system

Click here

Panoramic view monitor system

Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips


  • Use the same procedure as for the LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    B004U54

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    CAUTION:


    • B004UM0

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    • SRS parts are equipped with a backup power source. If work is started within 90 seconds of turning the power switch off and disconnecting the cable from the negative (-) auxiliary battery terminal, SRS parts may deploy.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  5. REMOVE ION GENERATOR SUB-ASSEMBLY


    1. B004XPCC01
      B004SZX Screw
      B004UK4 Air duct
      B004RMI Pull out direction

      for LHD:


      1. Remove the 2 screws.

      2. Slide in the direction of the arrow shown in the illustration and pull out the ion generator sub-assembly with air duct sub-assembly.

    2. B004TJZC02
      B004SZX Screw
      B004UK4 Air duct
      B004RMI Pull out direction

      for RHD:


      1. Remove the 2 screws.

      2. Slide in the direction of the arrow shown in the illustration and pull out the ion generator sub-assembly with air duct sub-assembly.

    3. B004SD2C01
      B004RMI Pull Directly Up

      Detach the claw and remove the air duct sub-assembly from the ion generator assembly.