CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the luggage compartment door removal/installation are shown below.
Replacement Part | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
---|---|---|---|
Rear television camera assembly (Including removal and installation) |
|
|
|
|
Parking assist monitor system | ||
When the luggage compartment door is opened using a mechanical key | Initialize luggage closer motor assembly | The power trunk lid does not operate |
PROCEDURE
REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP
Using a screwdriver with its tip wrapped with protective tape, detach the claw and open the cover.
Remove the 2 screws and luggage compartment assist grip.
REMOVE SWITCH BEZEL
Detach the claw and remove the switch bezel.
REMOVE NO. 2 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
REMOVE LUGGAGE COMPARTMENT DOOR COVER
Using a clip remover, remove the clip.
Detach the clip and remove the luggage compartment door cover.
REMOVE DOOR CONTROL SWITCH
REMOVE LUGGAGE DOOR CLOSER ASSEMBLY
REMOVE LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY
Remove the 2 nuts and disconnect the luggage compartment door lock cylinder assembly.
Pull Out |
Detach the clamp of the luggage door lock control cable sub-assembly.
Pull out the luggage door lock control cable sub-assembly together with the luggage compartment door lock cylinder assembly in the direction indicated by the arrow shown in the illustration.
REMOVE LUGGAGE COMPARTMENT KEY CYLINDER PROTECTOR
Remove the nut and luggage compartment key cylinder protector.
REMOVE LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY
Remove the luggage door lock control cable sub-assembly from the luggage compartment door lock cylinder assembly.
REMOVE REAR LIGHT ASSEMBLY LH
REMOVE REAR LIGHT ASSEMBLY RH
Use the same procedure for the RH and LH sides.
REMOVE UPPER LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH LH
REMOVE UPPER LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH RH
REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
REMOVE REAR LUGGAGE TRIM CLIP
Detach the claw and remove the rear luggage trim clip.
Use the same procedure for the RH and LH sides.
REMOVE TELEVISION CAMERA ASSEMBLY
REMOVE LUGGAGE ELECTRICAL KEY SWITCH
REMOVE LICENSE PLATE LIGHT ASSEMBLY
REMOVE LUGGAGE COMPARTMENT FLOOR MAT
Remove in this Direction |
Holding the strap, lift the luggage compartment floor mat in the direction indicated by the arrow shown in the illustration and remove it.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Remove in this Direction |
Holding the strap, lift the luggage compartment mat sub-assembly in the direction indicated by the arrow shown in the illustration and remove it.
REMOVE LUGGAGE COMPARTMENT TRIM COVER LH
Remove in this Direction |
Holding the strap, lift the luggage compartment trim cover LH in the direction indicated by the arrow shown in the illustration, detach the pin and remove it.
REMOVE LUGGAGE COMPARTMENT TRIM COVER RH
Remove in this Direction |
Holding the strap, lift the luggage compartment trim cover RH in the direction indicated by the arrow shown in the illustration, detach the pin and remove it.
REMOVE TOOL BOX
Remove in this Direction |
Remove the tool box.
REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER
Using a clip remover, detach the 8 clips and remove the inner lower luggage compartment trim cover.
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/o Rear Air Conditioning System)
Using a clip remover, remove the 3 clips.
Using a clip remover, remove the 3 clips.
Place Hand Here | Remove in this Direction (1) | ||
Remove in this Direction (2) | - | - |
Place your hands at the positions shown in the illustration and bend the front luggage compartment trim cover down.
While bending the front luggage compartment trim cover toward the inside, pull it out in the direction indicated by the arrow shown in the illustration to remove it.
Do not bend the front luggage compartment trim cover so far that it breaks.
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (w/ Rear Air Conditioning System)
Use the same procedure described for the front luggage compartment trim cover (w/o Rear Air Conditioning System).
REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER
Using a clip remover, remove the 6 clips.
Remove in this Direction | |
Push |
Push the lever in the direction of the arrow shown in the illustration and remove the rope hook.
Use the same procedure for the opposite side.
Place Hand Here | Remove in this Direction (1) | ||
Remove in this Direction (2) | - | - |
Place your hands at the positions shown in the illustration, and while bending the rear luggage compartment trim cover toward the inside of the vehicle, pull it out to remove it.
Do not bend the rear luggage compartment trim cover so far that it breaks.
REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH
Remove the 4 clips and luggage compartment door hinge cover LH.
REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH
Use the same procedure for the RH and LH sides.
REMOVE LUGGAGE COMPARTMENT DOOR CUSHION
Detach the claw and remove the luggage compartment door cushion.
Use the same procedure for the RH and LH sides.