PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED
| Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | See page |
|---|---|---|
| Correction of steering angle neutral point | Steering effort varies | |
| Parking assist monitor system | ||
| Luggage closer motor assembly | Power trunk lid system | |
| Servo motors initialization | Air conditioning system | |
| Memory registration | Memory call function |
Note
After the power switch is turned off, the multi-media module receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
| Condition | Waiting Time |
|---|---|
| Vehicle enrolled in G-BOOK system (w/ Emergency Call Switch) | 6 minutes |
|
1 minute |
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
| Replacement Part | Necessary Procedures | Effects / Inoperative Functions When Necessary Procedures are not Performed | See Page |
|---|---|---|---|
|
Initialization | Engine control system | |
| Lane recognition camera sensor Tech Tips Replaced or removed and installed |
Lane recognition camera sensor adjustment | Lane-keeping assist system does not operate normally | |
| Driving support ECU | Initialization | DTCs are output | |
| Millimeter wave radar sensor assembly | Adjusting the radar beam axis | Dynamic radar cruise control system does not operate normally | |
|
Perform clutch oil pressure value learning initialization | Large shift shock | |
| Absorber control ECU | Test mode procedure | Adaptive variable suspension system | |
|
|
Tire pressure warning system | Click here (for Registration) Click here (for Initialization) |
| Skid control ECU assembly |
|
|
Click here (for Initialization) Click here (for Calibration) |
| Brake actuator assembly | Bleed air |
|
|
|
|
||
|
|
|
|
| Yaw rate sensor |
|
VSC and ABS do not operate | |
| Electric parking brake ECU | Initialization | Electric parking brake system | |
| Parking brake with bracket actuator assembly Tech Tips Replaced or removed and installed |
|
||
Tech Tips Replaced or removed and installed |
Parking brake bedding | ||
|
Calibration | Power steering system | |
|
Calibration and initialization | Variable gear ratio steering system | Click here (for Initialization) Click here (for Calibration) |
|
Calibration | Dynamic rear steering system | |
| Multi-media module receiver assembly | Initialization | Parking assist monitor system | |
| Spiral cable sub-assembly |
|
||
| Suspension, tires, etc. | Rear television camera optical axis (Back camera position setting) | ||
| Rear television camera assembly | |||
|
Adjusting the night view camera assembly | Night view system does not operate normally | |
| Inner rear view mirror assembly | Register transmitter code | Garage door opener function | |
| w/ Emergency Call Switch
w/o Emergency Call Switch
|
Vehicle contract setting |
|
Click here (w/ Telematics Transceiver) Click here (w/o Telematics Transceiver) |
| Hard disc | Download necessary data | Some G-BOOK service content will be unavailable | Click here (w/ Telematics Transceiver) Click here (w/o Telematics Transceiver) |
|
Registration |
|
Refer to the Service Bulletin for the registration method |
|
Initialization servo motor (Air conditioning system) | Air conditioning system | |
| Air Conditioning Amplifier Assembly | Memory registration | Memory call function | |
|
Position sensor initialization |
|
|
|
Initialize power window control system |
|
|
|
Initialize sliding roof system |
|
|
|
Initialization | Power trunk lid system | |
|
Initialization |
|