HOOD LOCK CONTROL CABLE ASSEMBLY(for LHD) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the hood lock control cable assembly removal/installation are shown below.

Replacement Part Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

Front television camera view adjustment Panoramic view monitor system

Click here

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. REMOVE RADIATOR COVER PLATE

    Click here

  3. REMOVE RADIATOR LOWER AIR DEFLECTOR

    Click here

  4. REMOVE FRONT FENDER REINFORCEMENT SUB-ASSEMBLY TOP LH

    Click here

  5. REMOVE FRONT BUMPER COVER


    1. except Sport Package

      Click here

    2. for Sport Package

      Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. B004XUS

      Detach the claw and remove the hood lock control lever sub-assembly.

    2. B004SL1

      Disconnect the hood lock control lever sub-assembly from the hood lock control cable assembly.

  8. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR

    Click here

  9. REMOVE HOOD LOCK ASSEMBLY

    Click here

  10. REMOVE HOOD LOCK CONTROL CABLE COVER LH


    1. B004SOH

      Remove the screw.

    2. Detach the claw and remove the hood lock control cable cover LH.

    3. Disconnect the hood lock control assembly.

      Click here

    4. B004WGPC01
      B004RMI Remove in this Direction

      Pull out the hood lock control cable assembly and hood lock control assembly from the hood lock control cable cover LH as shown in the illustration.

  11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. B004SD0C23
      *1 String

      Tie a string to the end of the hood lock control cable assembly in the cabin.

    2. Using a screwdriver with its tip wrapped with protective tape, detach the clamps and remove the hood lock control cable assembly.

      B004YKBC01
      *1 Hood Lock Control Cable Assembly *2 Stopper

    3. Pull the hood lock control cable assembly into the engine room.

      Tech Tips

      Do not pull off the string, because it is used during installation. Leave it on the vehicle.

    4. Disconnect the string from the hood lock control cable assembly.