REAR AIR CONDITIONING PANEL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear power seat switch removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Stereo Camera type:Click here for Mono Camera type:Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Mono camera type)
		Pre-collision system (for Stereo camera type)
		Adaptive high beam system
		Lighting system (EXT) cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Steering sensor (Including removal and installation)	Steering angle neutral point	Parking support brake system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Steering angle setting	Parking assist monitor system	Click here
	Steering angle setting	Panoramic view monitor system	Click here

*: When performing learning using the GTS. Click hereClick here

Click here

PROCEDURE

Click here
PRECAUTION

Note:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here
Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click here

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
Click here
REMOVE NO. 2 REAR SEAT CENTER ARMREST PANEL SUB-ASSEMBLY
1. Remove in this Direction
  
  Detach the clip and claw.
2. While moving the No. 2 rear seat center armrest panel sub-assembly in the direction indicated by the arrow shown in the illustration, detach the guide to remove it.
Click here
REMOVE NO. 2 REAR SEAT CENTER ARMREST PANEL
1. Remove in this Direction
  
  Detach the clip and claw.
2. While moving the No. 2 rear seat center armrest panel in the direction indicated by the arrow shown in the illustration, detach the guide to remove it.
Click here
REMOVE REAR POWER SEAT SWITCH WITH BRACKET
1. Remove the 4 screws and disconnect the rear power seat switch with bracket from the rear seat center armrest assembly.
Click here
REMOVE REAR SEAT CENTER ARMREST BRACKET RH
1. Remove the 2 screws and rear seat center armrest bracket RH.
Click here
REMOVE REAR SEAT CENTER ARMREST BRACKET LH
1. Remove the 2 screws and rear seat center armrest bracket LH.
Click here
REMOVE REAR SEAT CENTER ARMREST COVER
1. Remove the rear seat center armrest cover.
Click here
REMOVE REAR POWER SEAT SWITCH
1. Disconnect the connector, detach the clamp and remove the rear power seat switch.

REAR AIR CONDITIONING PANEL REMOVAL