FRONT SEATBACK HEATER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the separate type front seatback cover (front seatback heater) removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

for 8GR-FKS: Click here

for V35A-FTS: Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic View Monitor System

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here


  • Power seat switch LH (Including removal and installation)

  • Power seat switch RH (Including removal and installation)

  • Front seat headrest assembly (Including removal and installation)

  • Front seatback frame sub-assembly LH (Including removal and installation)

  • Front seatback frame sub-assembly RH (Including removal and installation)

 Initialize position control ECU Front Power Seat Control System

Click here


    for Front Passenger Side with Occupant classification System:

  • Front seat assembly RH (Only for removal and installation)

  • Occupant detection ECU (Including removal and installation)

 Zero point calibration (Occupant classification system)

  • Occupant classification system

  • Passenger airbag ON/OFF indicator

  • Airbag system (Front passenger side)

  • Seat belt warning system (Front passenger)

Click here

*: When performing learning using the GTS.
Click here Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B006B4P

Note


  • If the front seat airbag assembly LH was deployed, replace the front seat airbag assembly LH, front seatback frame sub-assembly LH, separate type front seatback pad, separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    B006BC1

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY

    Click here

  3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Seat)

    Click here

  4. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Seat)

    Click here

  5. REMOVE FRONT POWER ADJUSTER SHIELD LH

    Click here

  6. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  8. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

    Click here

  9. REMOVE FRONT SEAT HEADREST ASSEMBLY

    Click here

  10. REMOVE FRONT SEATBACK BOARD

    Click here

  11. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  12. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

    Click here

  13. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    1. except Front Passenger Side Folding Headrest:


      1. B0069TA

        Remove the 4 hog rings and pull out the strap.

    2. w/ Front Passenger Side Folding Headrest:


      1. B006GCNC01
        *a Fastening Tape

        Remove the 6 hog rings.

      2. Detach the fastening tape and pull out the strap.

    3. for Standard Seat Type:


      1. B006BPJ

        Remove the 10 hog rings and separate type front seatback cover.

    4. for Sports Seat Type:


      1. B006ED4C01
        *a Fastening Tape

        Remove the 10 hog rings.

      2. Detach the fastening tape and remove the separate type front seatback cover.

  14. REMOVE SEAT COVER WIRE

    Click here