INITIALIZE REAR DOOR SUNSHADE SYSTEM
Note
If the following operations are performed, initialization of the rear door sunshade system (end point learning) is necessary.
The cable to the negative (-) battery terminal is disconnected.
A power source system fuse of the rear door sunshade system is disconnected and reconnected.
The rear multiplex network door ECU LH or rear multiplex network door ECU RH is replaced or the connectors are disconnected.
The rear door sunshade system does not operate unless the rear door sunshade system is initialized.
A close operation is performed using any of the following operations.
The right or left rear door sunshade is opened using the multiplex network master switch assembly.
Note
This check is possible only when the "Rear Left Master SW Shade Function" or "Rear Right Master SW Shade Function" customization setting using the GTS is set to ON (initial setting is ON).
The right or left rear door sunshade is opened using the power window regulator switch assembly (rear right or rear left seat).
The right or left rear door sunshade is opened using the rear power seat switch (w/ Rear Multi Operation Panel System).
A right or left rear door sunshade open operation is performed using the "Rear Door Sunshade Up" Active Test.