SUB BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the sub-battery module assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA /LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS.
Click here Click here

Note

After the engine switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the engine switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
REMOVE TOOL BOX

Click here
PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE BATTERY

Click here
REMOVE LUGGAGE COMPARTMENT FLOOR MAT

Click here
REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

Click here
REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

Click here
REMOVE SIDE TRIM BOX

Click here
REMOVE LUGGAGE COMPARTMENT TRIM BOX (w/ Luggage Compartment Trim Box)

Click here
REMOVE ROPE HOOK ASSEMBLY

Click here
REMOVE REAR FLOOR FINISH PLATE

Click here
REMOVE INNER LOWER LUGGAGE COMPARTMENT TRIM COVER

Click here
REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

Click here
REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

Click here
REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

Click here
REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

Click here
REMOVE REAR LUGGAGE COMPARTMENT TRAY BRACKET RH
1. Detach the claw and open the cap.
2. Remove the bolt and rope hook assembly.
3. Detach the clip and remove the rear luggage compartment tray bracket RH.
REMOVE CONNECTOR COVER
1. Detach the 2 claws and connector cover.
REMOVE SUB-BATTERY MODULE ASSEMBLY
1. Loosen the 2 nuts and disconnect the 2 sub-battery terminals from the sub-battery module assembly.
2. Disconnect the connector from the sub-battery module assembly.
3. Loosen the 2 nuts and disconnect the connector from the sub-battery module assembly.
REMOVE SUB-BATTERY BRACKET
1. Loosen the 2 bolts and remove the sub-battery bracket (negative (-) terminal side) from the sub-battery module assembly.
2. Loosen the 2 bolts and remove the sub battery bracket (positive (+) terminal side) from the sub-battery module assembly.