REAR SEAT CUSHION ADJUSTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat reclining adjuster sub-assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • cornering lights

Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here


  • Rear seat headrest assembly LH (Including removal and installation)

  • Rear seat headrest assembly RH (Including removal and installation)

  • Rear No.1 seat adjuster assembly (Including removal and installation)

  • Rear No.2 seat adjuster assembly (Including removal and installation)

  • No.1 seat reclining adjuster assembly RH (Including removal and installation)

Initialize position control ECU Rear power seat control system

Click here

*: When performing learning using the GTS.
Click here Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B006C5U

Note


  • If the rear seat cushion airbag assembly LH was deployed, replace the rear seat cushion panel LH, rear seat cushion pad and separate type rear seat cushion cover with the necessary parts in accordance with the extent of the collision damage.

  • If the rear seat airbag assembly LH was deployed, replace the rear seat sub panel sub-assembly LH, separate type rear seatback pad and separate type rear seatback cover with the necessary parts in accordance with the extent of the collision damage.

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) battery terminal.

      Click here

      CAUTION:

      B006BY6

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

  3. REMOVE REAR SEAT CUSHION ASSEMBLY LH

    Click here

  4. REMOVE REAR SEAT CUSHION ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  6. REMOVE REAR SEATBACK ASSEMBLY RH

    Click here

  7. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  8. REMOVE REAR NO. 2 SEAT ADJUSTER ASSEMBLY

    Click here

  9. REMOVE REAR NO. 1 SEAT ADJUSTER ASSEMBLY

    Click here

  10. REMOVE REAR CENTER SEAT LAP TYPE BELT ASSEMBLY RH

    Click here

  11. REMOVE REAR SEAT INNER BELT ASSEMBLY LH

    Click here

  12. REMOVE REAR SEAT INNER BELT ASSEMBLY RH

    Click here

  13. REMOVE REAR NO. 2 SEAT WIRE LH

    Click here

  14. REMOVE REAR SEAT LEGREST ASSEMBLY

    Click here

  15. REMOVE REAR SEAT LEGREST COVER

    Click here

  16. REMOVE REAR SEAT LEGREST COVER RH (w/ Ottoman)

    Click here

  17. REMOVE REAR SEAT LEGREST COVER (w/ Ottoman)

    Click here

  18. REMOVE REAR NO. 2 SEAT WIRE RH (w/ Ottoman)

    Click here

  19. REMOVE REAR SEAT RECLINING ADJUSTER SUB-ASSEMBLY LH


    1. B0069M8

      Remove the 4 bolts and rear seat reclining adjuster sub-assembly LH.

  20. REMOVE REAR SEAT RECLINING ADJUSTER SUB-ASSEMBLY RH


    1. w/o Ottoman:


      1. Use the same procedure described for the LH side.

    2. B006D43

      w/ Ottoman:


      1. Remove the 4 bolts and rear seat reclining adjuster sub-assembly RH.