SLIDING ROOF HOUSING(for Sliding roof) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof glass sub-assembly, sliding roof housing sub-assembly, sliding roof drive gear assembly or sliding roof drive cable sub-assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

for 8GR-FKS: Click here

for V35A-FTS:

Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic View Monitor System

Click here

Initialize Rear Door Sunshade System Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here


  • Roof glass (Including removal and installation)

  • Sliding roof drive gear sub-assembly

 Initialize sliding roof system

  • Auto function

  • Jam protection function

  • Key-off operation

  • Wireless transmitter-linked operation

  • Key-linked function

  • Open warning function may not operate

  • Sliding roof may become misaligned

Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

    B006BC1

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. B006FQP

      Remove the sliding roof side garnish LH from the rail.

  3. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. B0069YR

      Detach the claw to remove the sliding roof side garnish LH.

  5. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    1. Move the sliding roof glass sub-assembly to the fully closed position.

    2. Using a T25 "TORX" socket wrench, remove the 4 "TORX" screws and sliding roof glass sub-assembly.

      B006DWU

      Note

      When removing the sliding roof glass sub-assembly, move the sliding roof glass sub-assembly to the fully closed position.

  7. REMOVE SLIDING ROOF WEATHERSTRIP


    1. B006BRD

      Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.

  8. REMOVE CURTAIN SHIELD AIR BAG ASSEMBLY RH

    Click here

  9. REMOVE CURTAIN SHIELD AIR BAG ASSEMBLY LH

    Tech Tips

    Use the same procedure as for the RH side.

  10. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY


    1. B006EKN

      Remove the clip.

      Tech Tips

      Use the same procedure for the other 3 clips.

    2. Disconnect the 4 sliding roof drain hoses.

    3. Remove the 8 bolts, 8 nuts and sliding roof housing sub-assembly.

      B006A8T

      Note

      If the removed nut is the same shape as that shown in the illustration, replace it the supplied replacement part.

      B006G7H