GENERATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	LKA /LDA system	Click here
		Parking support brake system*
		Pre-collision system
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS.
Click here Click here

Note

After the engine switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the engine switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

PROCEDURE

PRECAUTION

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE FAN AND GENERATOR V BELT

Click here
DISCONNECT NO. 3 ENGINE WIRE

Click here
REMOVE AIR CLEANER SUPPORT BRACKET ASSEMBLY
1. Remove the 2 bolts and air cleaner support bracket assembly.
REMOVE GENERATOR ASSEMBLY
1. Remove the bolt and disconnect the engine wire.
2. Remove the terminal cap.
3. Detach the clamp.
4. Remove the nut and disconnect the engine wire from terminal B.
5. Disconnect the generator assembly connector.
6. *A for 2WD
  
  *B for AWD
  
  Remove the 4 bolts and disconnect the wire harness.
7. Remove the 2 bolt and 2 nuts.
8. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator assembly.
9. Vehicle front side
  
  Remove the generator assembly as shown in the illustration.

*A	for 2WD
*B	for AWD