TIRE PRESSURE WARNING RECEIVER(for Quarter Pillar) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

for 8GR-FKS: Click here

for V35A-FTS: Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

Tire pressure warning ECU and receiver

  • Register transmitter ID

  • Initialize tire pressure warning system

  • Perform tire position identification

  • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

  • Tire pressure warning function

for Initialization: Click here

for Registration: Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

  4. REMOVE REAR SEAT ASSEMBLY


    1. for Fixed Seat Type:

      Click here

    2. for Power Seat:

      Click here

  5. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  6. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  7. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

  8. REMOVE PACKAGE TRAY TRIM GARNISH LH

    Click here

  9. REMOVE PACKAGE TRAY TRIM SIDE COVER LH

    Click here

  10. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  11. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

    Note


    • Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject itto impact.

    • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with anew one.


    1. B006GG5

      Remove the bolt.

    2. Detach the 2 guides and tire pressure warning ECU and receiver.

    3. Disconnect the connector.