FUEL FILTER REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel suction plate sub-assembly (fuel filter) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

*: When performing learning using the GTS.
Click here Click here

CAUTION:


  • B006GQB

    Never perform work on fuel system components near any possible ignition sources.

  • Vaporized fuel could ignite, resulting in a serious accident.


  • B006AN0

    Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

  • Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

Note

Do not try to remove the black nylon tube as it is welded to the fuel suction tube with pump and gauge assembly.

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  4. REMOVE FUEL SENDER GAUGE ASSEMBLY

    Click here

  5. REMOVE NO. 1 FUEL SUB-TANK

    Click here

  6. REMOVE FUEL PUMP FILTER

    Click here

  7. REMOVE FUEL PUMP

    Click here

  8. REMOVE FUEL MAIN VALVE ASSEMBLY

    Click here

  9. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY (FUEL FILTER)


    1. B006CB3

      Detach the 2 claws to remove the No. 1 fuel suction support from the fuel suction plate sub-assembly (fuel filter).

      Note

      Do not damage the fuel suction plate sub-assembly (fuel filter).

  10. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY (FUEL FILTER)


    1. Attach the 2 claws to install the No. 1 fuel suction support to the fuel suction plate sub-assembly (fuel filter).

  11. INSTALL FUEL MAIN VALVE ASSEMBLY

    Click here

  12. INSTALL FUEL PUMP

    Click here

  13. INSTALL FUEL PUMP FILTER

    Click here

  14. INSTALL NO. 1 FUEL SUB-TANK

    Click here

  15. INSTALL FUEL SENDER GAUGE ASSEMBLY

    Click here

  16. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here