MAYDAY BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the mobilephone battery removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

for 8GR-FKS: Click here

for V35A-FTS: Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

Telematics transceiver assembly Register vehicle information Emergency call service

Click here

Mobile phone battery Reset mobilephone battery condition
*: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

    B006BC1

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Click here

    • If the airbag deploys for any reason, it may cause a serious accident.

    B006BY6

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE TELEMATICS TRANSCEIVER (for ERA-GLONASS)

    Click here

  5. REMOVE MOBILEPHONE BATTERY (for ERA-GLONASS)


    1. B006A31C01
      B006DHE Remove in this Direction (1)
      B006B42 Remove in this Direction (2)

      Remove the 2 screws.

      Tech Tips

      Remove the 2 screws together with the battery cover.

    2. Detach the claw and guide and remove the battery cover as shown in the illustration

    3. Disconnect the connector and remove the mobilephone battery as shown in the illustration.

      B006H16C01
      B006DHE Remove in this Direction (1) B006B42 Remove in this Direction (2)

  6. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for G-BOOK)

    Click here

  7. REMOVE PASSENGER SIDE JUNCTION BLOCK ASSEMBLY WITH NETWORK GATEWAY ECU (for G-BOOK)

    Click here

  8. REMOVE MAYDAY BATTERY WITH BRACKET (for G-BOOK)


    1. B006DJC

      Detach the clamp.

    2. Remove the 2 bolts.

    3. Detach the guide.

    4. B006FIC

      Disconnect the connector and remove the mayday battery with bracket.

  9. REMOVE MAYDAY BATTERY (for G-BOOK)


    1. B006C6O

      Remove the nut.

    2. Detach the claw and remove the mayday battery with bracket as shown in the illustration.

      B006B3MC01
      B006DHE Remove in this Direction (1) B006B42 Remove in this Direction (2)
    3. B006EZO

      Remove the No. 2 telephone bracket.