CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear seat airbag assembly removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
---|---|---|---|
Disconnect cable from negative (-) battery terminal | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and start system | for 8GR-FKS: for V35A-FTS: |
Memorize steering angle neutral point | LKA/LDA system | ||
Parking support brake system* | |||
Pre-collision system | |||
Adaptive high beam system | |||
Lighting system (EXT) |
|||
Variable gear ratio steering system | |||
Parking assist monitor system | |||
Panoramic View Monitor system | |||
Initialize Rear Door Sunshade System | Rear door sunshade system | ||
Initialize power trunk lid system | Power trunk lid system | ||
|
Initialize position control ECU | Rear power seat control system |
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 8GR-FKS:
for V35A-FTS:
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD LH
REMOVE REAR SEAT AIRBAG ASSEMBLY LH
CAUTION:
When storing the rear seat airbag assembly LH, keep the airbag deployment side facing upward.
If the airbag deploys for any reason, it may cause a serious accident.
Deployment Side |
Detach the claw and disconnect the airbag connector.
Remove the 2 nuts and rear seat airbag assembly LH.
CAUTION:
Do not reuse the nut.
If the installation surface or surrounding area of the rear seat airbag assembly LH is deformed or damaged, replace the rear seat sub panel sub-assembly LH with a new one.