CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the digital audio broadcasting antenna removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
---|---|---|---|
Disconnect cable from negative battery terminal | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and start system | for 8GR-FKS: Click here for V35A-FTS: Click here |
Memorize steering angle neutral point | LKA/LDA system | ||
Parking support brake system* | |||
Pre-collision system | |||
Adaptive high beam system | |||
Lighting system (EXT) |
|||
Variable gear ratio steering system | |||
Parking assist monitor system | |||
Panoramic view monitor system | |||
Initialize rear door sunshade system | Rear door sunshade system | ||
Initialize power trunk lid system | Power trunk lid system | ||
|
Adjust forward recognition camera |
|
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 8GR-FKS:
for V35A-FTS:
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE ROOF HEADLINING ASSEMBLY
REMOVE DIGITAL AUDIO BROADCASTING ANTENNA ASSEMBLY
Disconnect the 2 connectors.
Remove the 2 nuts.
Detach the 2 guides, and remove the digital audio broadcasting antenna assembly.
Note
Do not touch the contact terminal of the digital audio broadcasting antenna assembly.
*A | for LH Side | *B | for RH Side |
Nut | Connector |