CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
---|---|---|---|
Disconnect cable from negative battery terminal | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and start system | |
Memorize steering angle neutral point | LKA/LDA system | ||
Parking support brake system* | |||
Pre-collision system | |||
Adaptive high beam system | |||
Lighting system (EXT) |
|||
Variable gear ratio steering system | |||
Parking assist monitor system | |||
Panoramic view monitor system | |||
Initialize rear door sunshade system | Rear door sunshade system | ||
Initialize power trunk lid system | Power trunk lid system |
Note
After the engine switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the engine switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
REMOVE TOOL BOX
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE EXHAUST MANIFOLD ASSEMBLY LH
REMOVE STARTER COVER
Remove the 2 bolts and starter cover.
REMOVE STARTER ASSEMBLY
Detach the claw and open the terminal cover.
Remove the nut and disconnect the starter wire.
Connector | |
Bolt |
Disconnect the connector.
Remove the 2 bolts and starter assembly.
REMOVE FLYWHEEL HOUSING SIDE COVER
Remove the flywheel housing side cover.