COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point LKA/LDA System

Click here

Intelligent clearance sonar system*1
Pre-crash safety system

Lighting system (EXT)


  • Cornering lights

Adaptive high beam system
Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point Parking assist monitor system (w/ Parallel parking assist function)

Click here

Parking assist monitor system (w/o Parallel parking assist function)

Click here

Panoramic view monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Reset back door close position Power back door system

Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE INSTRUMENT PANEL GARNISH

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  6. REMOVE COWL SIDE TRIM BOARD

    Click here

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    Click here

  10. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  11. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  12. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

    Click here

  13. REMOVE LOWER INSTRUMENT FINISH PANEL SUB

    Click here

  14. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. B007XJ4

      Disengage the 2 claws and 4 clips to separate the instrument cluster finish panel sub-assembly.

    2. B007XIRC01
      B008043 Place Hand Here
      B007Z37 Remove in this Direction

      Disengage the 4 clips as shown in the illustration.

    3. B007WLIC01
      B008043 Place Hand Here
      B007Z37 Remove in this Direction

      Disengage the 3 clips as shown in the illustration.

    4. Disconnect the connector to remove the instrument cluster finish panel sub-assembly.

  15. REMOVE COMBINATION METER ASSEMBLY


    1. B007Z3K

      Remove the 4 screws.

    2. Disengage the clamp.

    3. Disconnect each connector to remove the combination meter assembly.