CLEARANCE WARNING ECU(for LHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

  4. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  5. REMOVE COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  6. REMOVE FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  7. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  8. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  10. REMOVE INSTRUMENT PANEL BOX DOOR COVER

    Click here

  11. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  12. REMOVE ECU INTEGRATION BOX RH


    1. Disconnect each connector.

    2. B001OKA

      Remove the bolt, 2 nuts and ECU integration box RH.

  13. REMOVE CLEARANCE WARNING ECU ASSEMBLY


    1. B001NOB

      Disengage the 2 claws and remove the clearance warning ECU assembly.