WATER PUMP REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA /LDA system	Click here
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking assist monitor system (w/ Parallel parking assist function)	Click here
		Parking assist monitor system (w/o Parallel parking assist function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here
Replacement of ECM	Perform Vehicle Identification Number (VIN) or frame number registration	MIL illuminates / - DTC P063051 is stored	Click here for 2GR-FKS (w/ Canister Pump Module) Click here for 2GR-FKS (w/o Canister Pump Module)
	ECU Communication ID Registration (Immobiliser system)	Engine start function	See Service Bulletin for the registration method.
	Perform code registration (Immobiliser system)	Wireless door lock control system Entry and start system Engine start function Steering lock system Telematics system	See Service Bulletin for the registration method.
Gas leaks from exhaust system	Inspection After Repair	Poor idle, etc. Engine start function, etc.	Click here for 2GR-FKS (w/ Canister Pump Module) Click here for 2GR-FKS (w/o Canister Pump Module)
Suspension, tires, etc. (The vehicle height changes because of suspension or tire replacement)	Rear television camera assembly optical axis (Back camera position setting)	Parking assist monitor system (w/ Parallel Parking Assist Function)	Click here for Initialization Click here for Calibration
		Parking assist monitor system (w/o Parallel Parking Assist Function)	for Calibration Click here for Initialization Click here
	Parking assist ECU initialization Adjust steering angle	Panoramic view monitor system	Click here for Initialization Click here for Calibration
	Initialize headlight ECU sub-assembly LH	Adaptive high beam system Automatic headlight beam level control system	Click here
Front wheel alignment adjustment	Clear zero point calibration data and system information. Perform yaw rate and acceleration sensor zero point calibration and store system information.	VSC disabled or malfunctions DTCs are stored Slip indicator light illuminates ABS warning light illuminates	Click here

PROCEDURE

REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Click here
REMOVE V-RIBBED BELT

Click here
REMOVE COMPRESSOR AND MAGNETIC CLUTCH

Click here
REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
1. Remove the bolt and No. 2 idler pulley sub-assembly.
REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
1. Remove the 2 bolts and V-ribbed belt tensioner assembly.
REMOVE WATER PUMP PULLEY
1. Using SST, hold the water pump pulley.
  
  SST
  
  09960-10010 ( 09962-01000, 09963-00700 )
2. Remove the 4 bolts and water pump pulley.
REMOVE ENGINE WATER PUMP ASSEMBLY
1. Remove the 15 bolts, engine water pump assembly, water pump pulley and water pump gasket.