CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Engage the 12 hooks to temporarily install the curtain shield airbag assembly.

      A01CCVQ

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    4. Install the 12 bolts.

      A01CF7B
      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    5. Connect the 2 curtain shield airbag connectors.

      A01CGHC

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    6. Engage the 2 wire harness clamps.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure from "Install Roof Headlining Assembly" Click here.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.

  5. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.