THERMOSTAT REMOVAL

PROCEDURE

REMOVE REAR MOTOR UNDER COVER LH

Click here
DRAIN ENGINE COOLANT (for Engine)

Click here
REMOVE RADIATOR SUPPORT OPENING COVER

Click here
REMOVE INLET NO. 2 AIR CLEANER

Click here
REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Click here
REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Click here
REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Click here
REMOVE AIR CLEANER BRACKET

Click here
REMOVE INLET NO. 1 AIR CLEANER

Click here
REMOVE ENGINE OIL LEVEL DIPSTICK
1. Remove the engine oil level dipstick from the engine oil level dipstick guide.
REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
1. Disengage the clamp to disconnect the engine wire from the engine oil level dipstick guide.
2. Remove the bolt and engine oil level dipstick guide from the cylinder block sub-assembly and oil pan sub-assembly.
3. Remove the engine oil level dipstick guide O-ring from the engine oil level dipstick guide.
REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
1. *1 No. 2 Radiator Hose
  
  *2 No. 3 Water By-pass Hose
  
  Slide the 2 clips and disconnect the No. 2 radiator hose and No. 3 water by-pass hose from the water inlet with thermostat sub-assembly.
  Note
  
  Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 3 water by-pass hose.
  
  Do not damage the water inlet with thermostat sub-assembly.
  Tech Tips
  
  When disconnecting the No. 3 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.
2. Type A:
  1. Remove the 2 nuts, bolt and water inlet with thermostat sub-assembly.
  2. Remove the gasket from the water inlet with thermostat sub-assembly.
3. Type B:
  1. Remove the 3 bolts and water inlet with thermostat sub-assembly.
  2. Remove the gasket from the water inlet with thermostat sub-assembly.

*1	No. 2 Radiator Hose
*2	No. 3 Water By-pass Hose