CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during throttle body assembly removal/installation are shown below.
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
---|---|---|---|
|
Inspection After Repair |
|
Click here w/ Canister Pump Module Click here w/o Canister Pump Module |
CAUTION:
Do not remove the reserve tank cap, air release valve (w/ air release valve) or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
PROCEDURE
REMOVE REAR MOTOR UNDER COVER LH
DRAIN ENGINE COOLANT (for Engine)
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Disconnect the mass air flow meter sub-assembly connector.
Disconnect the wire harness clamp.
*a | Clamp |
*b | Guide |
Disengage the 2 clamps.
Disengage the 2 guides and remove the air cleaner cap sub-assembly from the air cleaner case sub-assembly.
Loosen the hose clamp and remove the air cleaner cap sub-assembly from the air cleaner hose assembly.
REMOVE AIR CLEANER HOSE ASSEMBLY
Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.
Loosen the hose clamp and remove the air cleaner hose assembly from the throttle body assembly.
REMOVE THROTTLE BODY ASSEMBLY
*A | w/ Stud Bolt |
*B | w/o Stud Bolt |
*1 | Water By-pass Hose |
*2 | No. 2 Water By-pass Hose |
Disconnect the throttle body assembly connector.
Slide the 2 clips and disconnect the water by-pass hose and No. 2 water by-pass hose from the throttle body assembly.
*A | w/ Stud Bolt |
*B | w/o Stud Bolt |
w/ Stud Bolt:
Remove the 2 bolts, 2 nuts and throttle body assembly from the intake manifold.
w/o Stud Bolt:
Remove the 4 bolts and throttle body assembly from the intake manifold.
REMOVE THROTTLE BODY GASKET
*A | w/ Stud Bolt |
*B | w/o Stud Bolt |
Remove the throttle body gasket from the intake manifold.