KNEE AIRBAG ASSEMBLY(for Front Passenger Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  7. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

  8. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH

    Click here

  9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. B0018J6

      Remove the 4 bolts.

    2. Detach the 4 claws and remove the front passenger side knee airbag assembly.

    3. B0019HUE01
      Text in Illustration
      *a Connector Lock
      B0019VB Protective Tape

      Using a screwdriver, release the connector lock and disconnect the airbag connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

      Tech Tips

      Tape the screwdriver tip before use.