CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
Put protective tape around the lower instrument panel pad sub-assembly LH.
*a | Protective Tape |
Detach the 5 claws and 2 clips.
Disconnect the connector and remove the lower instrument panel pad sub-assembly LH.
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
Put protective tape around the lower instrument panel pad sub-assembly RH.
*a | Protective Tape |
Detach the 15 claws and remove the lower instrument panel pad sub-assembly RH.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Detach the 2 claws and disconnect the shifting hole cover.
Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.
REMOVE UPPER CONSOLE BOX
Put protective tape around the upper console box.
*a | Protective Tape |
Using a moulding remover A, detach the 4 clips and remove the upper console box.
REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Put protective tape around the instrument panel finish panel end LH.
*a | Protective Tape |
Detach the 2 clips and 7 guides and remove the instrument panel finish panel end LH.
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Put protective tape around the instrument panel finish panel end RH.
*a | Protective Tape |
Detach the 2 clips and 7 guides and remove the instrument panel finish panel end RH.
REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Put protective tape around the lower center instrument cluster finish panel sub-assembly.
*a | Protective Tape |
Using a moulding remover A, detach the 2 claws and 2 clips and remove the lower center instrument cluster finish panel sub-assembly.
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Put protective tape around the upper console panel sub-assembly.
*a | Protective Tape |
Detach the 6 claws and 2 guides.
Disconnect the connectors and remove the upper console panel sub-assembly.
REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
Put protective tape around the rear console end panel sub-assembly.
*a | Protective Tape |
Using a moulding remover B, detach the 6 claws.
Disconnect the connectors and remove the rear console end panel sub-assembly.
REMOVE TELEMATICS TRANSCEIVER (w/ Telematics Transceiver)
REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
Remove the 4 bolts and 2 screws.
Detach the 2 claws and remove the rear console box sub-assembly.
*a | Screw | *b | Bolt |