4WD CONTROL ECU(for RHD) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

   Click here

4. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH

   Click here

5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

6. REMOVE FRONT DOOR SCUFF PLATE RH

   Click here

7. REMOVE COWL SIDE TRIM BOARD RH

   Click here

8. REMOVE INSTRUMENT SIDE PANEL RH

   Click here

9. REMOVE NO. 1 SWITCH HOLE BASE

   Click here

10. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

11. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY

    Click here

12. REMOVE INSTRUMENT PANEL BOX ASSEMBLY

    Click here

13. REMOVE COWL SIDE JUNCTION BLOCK RH

    Click here

14. REMOVE 4WD CONTROL ECU

    
    

    1. 

       Remove the bolt.

    2. Detach the 2 guides and disconnect the 4 wheel drive control ECU.

    3. Disconnect the 2 connectors from the 4 wheel drive control ECU.