4WD CONTROL ECU(for LHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  4. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

  7. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH

    Click here

  8. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIR BAG ASSEMBLY

    Click here

  9. REMOVE INSTRUMENT PANEL BOX DOOR KNOB

    Click here

  10. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  11. REMOVE COWL SIDE JUNCTION BLOCK RH

    Click here

  12. REMOVE 4 WHEEL DRIVE CONTROL ECU


    1. B001A7K

      Remove the bolt.

    2. Detach the 2 guides and disconnect the 4 wheel drive control ECU.

    3. Disconnect the 2 connectors from the 4 wheel drive control ECU.

    4. Remove the bolt and ECU.