STOP LIGHT CONTROL RELAY(for LHD) REMOVAL

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  5. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  7. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

    Click here

  8. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH

    Click here

  9. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  10. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  11. REMOVE DOOR CONTROL BATTERY WITH BRACKET

    Click here

  12. REMOVE STOP LIGHT CONTROL RELAY ASSEMBLY


    1. B0018PB

      Disconnect the connector.

    2. Detach the clamp and remove the stop light control relay assembly.