KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. 

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Push in the lock to install the airbag connector.

   5. Attach the 3 claws to connect the hood lock control lever sub-assembly to the lower No. 1 instrument panel airbag assembly.

   6. Temporarily install the lower No. 1 instrument panel airbag assembly with the hook and pin.

   7. Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

3. INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

   Click here

4. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH

   Click here

7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL

   Click here

8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

9. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

10. INSPECT SRS WARNING LIGHT

    Click here

11. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

12. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here