PROCEDURE
PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing Click here.
INSTALL TIRE PRESSURE MONITOR INITIATOR DRIVER
Attach the 2 claws to install the tire pressure monitor initiator driver.
INSTALL ECU INTEGRATION BOX RH
Install the ECU integration box RH with the 2 nuts and bolt.
Connect all the connectors.
Note
Do not twist the connectors of the ECUs when connecting them.
Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.
INSTALL COWL SIDE JUNCTION BLOCK RH
Connect the 2 connectors.
Install the cowl side junction block RH to the reinforcement with the bolt and nut.
Connect the connector.
w/o VGRS System:
Attach the clamp.
Connect the connector.
w/ VGRS System:
Connect the 5 connectors.
Attach the 2 clamps.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
INSTALL INSTRUMENT SIDE PANEL RH
INSTALL FRONT DOOR OPENING TRIM COVER RH
INSTALL FRONT DOOR SCUFF PLATE RH
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL LUGGAGE COMPARTMENT TRIM COVER LH
INSTALL LUGGAGE COMPARTMENT FLOOR MAT
CHECK SRS WARNING LIGHT
INSPECT TIRE PRESSURE WARNING SYSTEM