BRAKE CONTROL POWER SUPPLY INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

PROCEDURE


  1. INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET


    1. A001E1Y

      Install the 2 brackets with the 4 bolts.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

  2. INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY


    1. A001CBU

      Connect the connector to the brake control power supply.

    2. Install the brake control power supply with the 3 nuts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL BRAKE CONTROL POWER SUPPLY COVER


    1. A001EA7E04
      Text in Illustration
      *1 Connector
      *a Double-sided Tape

      If the brake control power supply is replaced, install a new cover as follows:


      1. Peel off the peeling paper of the double-sided tape.

      2. Place the cover so that the 4 corner lines on the cover align with the corners of the brake control power supply, and so that the cover arrow is above the connector.

  4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL COWL TOP VENTILATOR LOUVER

    Click here

  7. CHECK AND CLEAR DTC

    Click here