ELECTRONICALLY CONTROLLED BRAKE SYSTEM DTC CHECK / CLEAR


  1. DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER)


    1. DTC check


      1. Connect the intelligent tester to the DLC3.

      2. Turn the engine switch on (IG).

      3. Read the DTCs following the prompts on the intelligent tester screen.

    2. DTC clear


      1. Connect the intelligent tester to the DLC3.

      2. Turn the engine switch on (IG).

      3. Operate the intelligent tester to clear the codes.

        Tech Tips

        Refer to the intelligent tester operator's manual for further details.

  2. DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE)


    1. A001B04E17

      DTC check


      1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

        SST
        09843-18040
      2. Turn the engine switch on (IG).

      3. Read DTC from the ABS warning light, brake warning light / yellow (minor malfunction), slip indicator light and brake hold standby indicator light on the combination meter and multi-information display.

        Tech Tips


        • When the system is normal, the relevant light turns on for 0.25 seconds and off for 0.25 seconds and repeats this pattern.

        • When only 1 DTC is stored, the relevant light outputs the same code after an interval of 4 seconds. Example: When DTC 42 is stored, the light blinks 4 times, turns off for 1.5 seconds, blinks twice, turns off for 4 seconds, and then repeats this output pattern.

        • When 2 or more DTCs are stored, the relevant light outputs the codes with an interval of 2.5 seconds between each different code, and the output of all codes repeats after an interval of 4 seconds.

        • Before connecting the terminals of the DLC3, if the brake hold operated indicator light is blinking, the brake hold operated indicator light stops blinking and turns off when terminals TC and CG of the DLC3 are connected.

        • If no code appears, inspect the TC and CG terminal circuit, ABS and brake warning light / yellow (minor malfunction) warning light circuits and brake hold standby and slip indicator light circuits.

        Trouble Area See procedure
        TC and CG terminal circuit

        Click here

        ABS warning light circuit

        or Click here

        Brake warning light / yellow (minor malfunction) circuit

        or Click here

        Slip indicator light circuit

        Click here

        Brake hold standby indicator light circuit

        Click here

      4. The codes are explained in the code table Click here.

      5. After completing the check, disconnect terminals TC and CG of the DLC3, and turn the display off.

        If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

    2. DTC clear


      1. A001B04E17

        Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

        SST
        09843-18040
      2. Turn the engine switch on (IG).

      3. A001D2A

        Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

      4. Check that the ABS warning light, brake warning light / yellow (minor malfunction), slip indicator light, brake hold standby indicator light and multi-information display indicate the normal system code.

      5. Remove SST from the terminals of the DLC3.

        Tech Tips

        Clearing the DTCs cannot be performed by removing the battery cable or the ECU-IG and D-IG1-3 fuse.

  3. END OF DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE)


    1. Turn the engine switch on (IG).

    2. Check that the ABS warning light, brake warning light / yellow (minor malfunction), slip indicator light and brake hold operated indicator light illuminate. After the engine is started, check that they turn off.