While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.
REMOVE COWL TOP VENTILATOR LOUVER
Remove the 6 clips and cowl top ventilator louver RH.
Remove the 6 clips and cowl top ventilator louver LH.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE CONSOLE BOX ASSEMBLY
REMOVE NO. 1 CONSOLE BOX DUCT
Detach the connector clamp (labeled A).
Detach the 2 connector clamps (labeled A).
Remove the 2 clips (labeled B) and No. 1 duct.
REMOVE YAW RATE SENSOR
The yaw rate sensor has an identification number. Make sure of the identification number when replacing the yaw rate sensor.
|Without slope determination function||9|
|With slope determination function||2|
Remove the 2 bolts and sensor.
Disconnect the sensor connector.
Do not drop the yaw rate sensor. If it is dropped, do not use it.