FRONT BUMPER(except Sport Package) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. INSTALL FRONT BUMPER ASSEMBLY


    1. B004VOIC01
      B004RMI Install in this Direction

      w/ Headlight Cleaner System:


      1. Connect the headlight cleaner hose.

    2. Attach the claw to temporarily install the front bumper assembly.

      Note

      Do not damage the front bumper assembly.

    3. B004WWNC01
      B004RMI Install in this Direction

      Attach the guide, claw and clip to install the front bumper assembly as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH and LH side.

    4. Remove the protective tape.

    5. B004S3B

      Connect the 2 connectors

    6. B004T2Q

      Install the 8 screws.

    7. B004WQGC01
      *1 Front Bumper Seal Bracket

      Install the front bumper seal bracket.

      Tech Tips

      Use the same procedure for the RH and LH side.

    8. Install the screw.

      Tech Tips

      Use the same procedure for the RH and LH side.

    9. B004YAT

      Install the 4 clips.

      Tech Tips

      Use the same procedure for the RH and LH side.

    10. B004V3R

      Install the 3 bolts.

  2. INSTALL LOWER RADIATOR AIR DEFLECTOR

    Click here

  3. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  4. INSTALL RADIATOR COVER PLATE

    Click here

  5. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  6. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. CHECK SRS WARNING LIGHT

    Click here

  9. ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)


    1. Add washer fluid to the washer jar.

  10. ADJUST HEADLIGHT AIMING

    Click here

  11. INITIALIZATION GRILLE SHUTTER SYSTEM (w/ Grille Shutter)


    1. Change the grille shutter control mode to normal mode and initialize the grille shutter system.

      Click here

  12. ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

    Click here

  13. PERFORM CALIBRATION

    Click here