REAR COMBINATION LIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH


    1. B004WZL

      Pass the wire harness into the vehicle cabin and install the grommet.

    2. B004RFNC01
      *a Guide
      *b Pin
      B004RMI Install in this Direction

      Set by aligning the guide of the rear combination light assembly LH.

    3. Push the rear combination light assembly LH toward the front of the vehicle, and attach the clip and pin.

    4. B004SQ2

      Install the 4 screws.

    5. B004V3S

      Connect the connector and return the luggage compartment trim inner cover LH to its original position.

  2. INSTALL REAR BUMPER ASSEMBLY

    Click here

  3. INSTALL REAR COMBINATION LIGHT COVER LH

    Click here

  4. INSTALL REAR COMBINATION LIGHT COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSTALL NO. 2 ROPE HOOK


    1. B004T9AC01
      B004UK4 Push
      B004RMI Install inn this Direction

      Set the No. 2 rope hook and push the 2 knobs to install the No. 2 rope hook.

  6. INSTALL REAR FLOOR FINISH PLATE

    Click here

  7. INSTALL ROPE HOOK ASSEMBLY

    Click here

  8. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  9. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  10. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  11. PERFORM SYSTEM CALIBRATION

    Click here