CHILD RESTRAINT SEAT ANCHOR BRACKET REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the child restraint seat anchor bracket sub-assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system (for Mono camera type)

for Stereo Camera type: Click here

for Mono Camera type: Click here

Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Stereo camera type)
Pre-collision system (for Mono camera type)
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

*: When performing learning using the GTS.
Click here Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    B004U54

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Click here

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

        Click here

      • If an SRS part is accidentally deployed, it may cause a serious injury.

      B004UM0

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click here

  4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

    Click here

  5. REMOVE NO. 1 SEAT ARMREST CAP (for Fixed Seat Type)

    Click here

  6. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)

    Click here

  7. REMOVE REAR SEAT CUSHION ASSEMBLY LH (for Power Seat)

    Click here

  8. REMOVE REAR SEATBACK ASSEMBLY LH (for Power Seat)

    Click here

  9. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  10. REMOVE REAR SEATBACK HOLDER (for Fixed Seat Type)

    Click here

  11. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH


    1. B004XMV

      Remove the bolt.

    2. Detach the guide and remove the child restraint seat anchor bracket sub-assembly LH.

  12. REMOVE INNER CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH


    1. B004R6H

      Remove the 2 bolts and inner child restraint seat anchor bracket sub-assembly LH.