REAR SEAT SIDE AIRBAG ASSEMBLY(for Fixed Seat Type)

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the instrument panel passenger airbag assembly removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Mono Camera type: Click here for Stereo Camera type: Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Mono camera type)
		Pre-collision system (for Stereo camera type)
		Adaptive high beam system
		Lighting system (EXT) cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic View Monitor System	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here

*: When performing learning using the GTS. Click hereClick here

Tip:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

Click here

PROCEDURE

Click here
PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here
Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click here

CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
Click here
REMOVE REAR SEATBACK ASSEMBLY

Click here
Click here
REMOVE REAR SEAT AIRBAG ASSEMBLY LH

CAUTION:
Deployment Side
- When storing the rear seat airbag assembly LH, keep the airbag deployment side facing upward.
- If the airbag deploys for any reason, it may cause a serious accident.
1. Remove the 3 hog rings and fold back the rear seatback cover.
2. Detach the wire harness clamp.
3. Remove the nut and disconnect the strap.
  
  CAUTION:
  
  Do not reuse the nut.
4. Remove in this Direction
  
  Remove the 4 nuts and rear seatback panel LH.
  
  CAUTION:
  - Do not reuse the nut.
  - If the installation surface or surrounding area of the rear seat airbag assembly LH is deformed or damaged, replace the rear seatback pad sub-assembly with a new one.
5. Remove the rear seat airbag assembly LH.

REAR SEAT SIDE AIRBAG ASSEMBLY(for Fixed Seat Type) REMOVAL