| DTC Code | DTC Name |
|---|---|
| B1635 | Curtain Shield Airbag Sensor (LH) |
| B1637 | Curtain Shield Airbag Sensor Lost Communication (LH) |
DESCRIPTION
The rear airbag sensor LH consists of a lateral deceleration sensor, etc.
If the airbag ECU assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.
DTC B1635 or B1637 is stored when a malfunction is detected in the rear airbag sensor LH circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B1635 | Curtain Shield Airbag Sensor (LH) | Either condition is met:
|
|
Comes on | Not applicable |
| B1637 | Curtain Shield Airbag Sensor Lost Communication (LH) | Either condition is met:
|
|
Comes on | Not applicable |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
PROCEDURE
CHECK DTC
Turn the power switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the power switch off.
Turn the power switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| Result | |||
|---|---|---|---|
|
Codes other than DTC B1635 and B1637 may be output at this time, but they are not related to this check.
USE SIMULATION METHOD TO CHECKClick here
CHECK REAR AIRBAG SENSOR LH
| *1 | Rear Airbag Sensor RH |
| *2 | Airbag ECU Assembly |
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.
Interchange the rear airbag sensor LH with RH and connect the connectors to them.
Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
Turn the power switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the power switch off.
Turn the power switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| Result | ||||
|---|---|---|---|---|
|
Codes other than DTC B1630, B1632, B1635 and B1637 may be output at this time, but they are not related to this check.
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.
Return the rear airbag sensor RH and LH to their original positions and connect the connectors to them.
REPLACE REAR AIRBAG SENSOR LHClick here
REPLACE AIRBAG ECU ASSEMBLYClick here
USE SIMULATION METHOD TO CHECKClick here