Click here

ENGINE HOOD COURTESY SWITCH REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the engine hood courtesy switch (hood lock assembly) removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Front bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here
Front television camera view adjustment Panoramic view monitor system

Click here
Tip:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

Click here

PROCEDURE


  1. Click here

    REMOVE FRONT BUMPER ASSEMBLY


    1. for Sport Package:

      Click here

    2. except Sport Package:

      Click here

  2. Click here

    REMOVE HOOD LOCK RELEASE LEVER PROTECTOR


    1. B004SW5

      Remove the 2 clips.

    2. Detach the clamp and remove the hood lock release lever protector.

  3. Click here

    REMOVE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    1. for LHD:


      1. B004VHBC01
        B004SZX Bolt
        B004UK4 Connector

        Disconnect the connector.

      2. Remove the 3 bolts and engine hood courtesy switch (hood lock assembly) from the vehicle.

      3. B004SSX

        Disconnect the hood lock control cable assembly and hood lock control assembly from the engine hood courtesy switch (hood lock assembly) and then remove the engine hood courtesy switch (hood lock assembly).

        Note:

        Do not bend the hood lock control cable assembly excessively.

    2. for RHD:


      1. B004ST8C01
        B004SZX Bolt
        B004UK4 Connector

        Disconnect the connector.

      2. Remove the 3 bolts and engine hood courtesy switch (hood lock assembly) from the vehicle.

      3. B004TAM

        Disconnect the hood lock control cable assembly and hood lock control assembly from the engine hood courtesy switch (hood lock assembly) and then remove the engine hood courtesy switch (hood lock assembly).

        Note:

        Do not bend the hood lock control cable assembly excessively.