ELECTRICAL KEY OSCILLATOR(for Outside Luggage Compartment) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the electrical key antenna removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
w/ Hands Free Power Trunk Lid Disconnect cable from negative auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Stereo Camera type: Click here for Mono Camera type: Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Mono camera type)
		Pre-collision system (for Stereo camera type)
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Rear bumper assembly (Including removal and installation)	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking support brake system	Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE

PRECAUTION (w/ Hands Free Power Trunk Lid)

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Hands Free Power Trunk Lid)

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Hands Free Power Trunk Lid)
Click here
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  
  Click here
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE REAR BUMPER ASSEMBLY

Click here
REMOVE REAR BUMPER ENERGY ABSORBER

Click here
REMOVE ELECTRICAL KEY ANTENNA
1. Connector
  
  Nut
  
  Disconnect the connector.
2. Remove the nut, detach the guide and remove the electrical key antenna.
  
  Note
  
  Do not reuse parts if dropped or subjected to any strong impact.

	Connector
	Nut