FRONT SIDE RADAR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front side radar sensor removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Front bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

Front television camera view adjustment Panoramic view monitor system

Click here

Note


  • Do not drop the front side radar sensor.

  • Do not drop the front side radar sensor. If it is dropped, replace it with a new one.

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY


    1. except Sport Package:

      Click here

    2. for Sport Package:

      Click here

  2. REMOVE FRONT SIDE RADAR SENSOR

    Tech Tips


    • Use the same procedure for the RH and LH side.

    • The following procedure is for the LH side.


    1. B004XUBC01
      B004SZX Connector
      B004UK4 Nut

      Disconnect the connector.

    2. Detach the wire harness clamp.

    3. Remove the 3 nuts and front side radar sensor.

      Tech Tips

      Replace nut with a new one.

  3. REMOVE FRONT FENDER REINFORCEMENT SUB-ASSEMBLY TOP LH

    Tech Tips

    Use the same procedure described for the RH side.

    Click here

  4. REMOVE HEADLIGHT ASSEMBLY LH

    Tech Tips

    Use the same procedure described for the RH side.

    Click here

  5. REMOVE FRONT SIDE RADAR SENSOR BRACKET LH

    Tech Tips

    Use the same procedure described for the RH side.


    1. B004SDS

      Remove the 3 bolts and front side radar sensor bracket LH.