BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1A47

DTC Code DTC Name
C1A47 Steering Angle Sensor

DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A47 Steering Angle Sensor A fail flag is transmitted from the steering sensor

  • Steering sensor

  • Blind spot monitor sensor LH

  • Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

Note


  • When checking for DTCs, make sure that the blind spot monitor system is turned on.

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

    Click here

  • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

PROCEDURE


  1. CHECK DTC


    1. Turn the power switch off.

    2. Turn the power switch on (IG).

    3. Recheck for DTCs and check if the same DTC is output again.


      Body Electrical > Blind Spot Monitor Master > Trouble Codes
      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  2. REPLACE STEERING SENSOR


    1. Replace the steering sensor with a new or known good one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. RECHECK DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > Blind Spot Monitor Master > Clear DTCs
      Body Electrical > Blind Spot Monitor Slave > Clear DTCs

    2. Recheck for DTCs and check if the same DTC is output again.


      Body Electrical > Blind Spot Monitor Master > Trouble Codes
      Body Electrical > Blind Spot Monitor Slave > Trouble Codes
      Result
      Result Proceed to
      No DTCs are output. A
      DTC C1A47 is output ("Blind Spot Monitor Master"). B
      DTC C1A47 is output ("Blind Spot Monitor Slave"). C

    A

    END (STEERING SENSOR WAS DEFECTIVE)

    B

    REPLACE BLIND SPOT MONITOR SENSOR RH Click here

    C

    REPLACE BLIND SPOT MONITOR SENSOR LH Click here