| DTC Code | DTC Name |
|---|---|
| C1AEA | Steering Angle Midpoint Initial Setting Incomplete |
DESCRIPTION
When the clearance warning ECU assembly detects that the steering angle neutral point memorization is incomplete during self diagnosis, C1AEA is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AEA | Steering Angle Midpoint Initial Setting Incomplete | Steering angle neutral point memorization incomplete |
|
CAUTION / NOTICE / HINT
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).
PROCEDURE
PERFORM CALIBRATION
Perform steering angle neutral point memorization.
| Result | ||
|---|---|---|
|
CHECK FOR DTC
Using the GTS, check for DTCs according to the prompts on the screen.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
If DTC C1AEA is output, perform steering angle neutral point memorization.
If DTC C1AEA is still output after performing steering angle neutral point memorization 3 times, replace the clearance warning ECU assembly.
| Result | ||||||
|---|---|---|---|---|---|---|
|
REPLACE CLEARANCE WARNING ECU ASSEMBLYClick here
USE SIMULATION METHOD TO CHECKClick here