REAR PACKAGE TRAY SPEAKER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear No. 3 speaker assembly and speaker assembly with bracket removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point LKA/LDA system (for Mono camera type)

for Stereo Camera type: Click here

for Mono Camera type: Click here

Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Mono camera type)
Pre-collision system (for Stereo camera type)
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read precaution thoroughly before servicing.

    Click here

    B004U54

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      Click here

    • If the airbag deploys for any reason, it may cause a serious accident.

    B004UM0

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. for Fixed Seat Type:

      Click here

    2. for Power Seat:

      Click here

  5. REMOVE REAR NO. 3 SPEAKER ASSEMBLY

    Note

    Do not touch the cone of the rear No. 3 speaker assembly.


    1. Disconnect the connector.

    2. Remove the 4 bolts and the rear No. 3 speaker assembly.

      B004WEBC03
      *A for 12 Speakers *B for 24 Speakers
      B004SZX Bolt B004UK4 Connector

  6. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH (for 24 Speakers)

    Click here

  7. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH (for 24 Speakers)

    Click here

  8. REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY (for 24 Speakers)

    Click here

  9. REMOVE REAR WINDOW SHADE ASSEMBLY (for 24 Speakers)

    Click here

  10. REMOVE SPEAKER ASSEMBLY WITH BRACKET (for 24 Speakers)

    Note

    Do not touch the cone of the speaker assembly with bracket.


    1. Disconnect the connector.

    2. Remove the bolt.

      B004VF7C03
      *A for RH Side *B for LH Side
      B004SZX Bolt B004UK4 Connector

    3. Detach the clip and remove the speaker assembly with bracket.

      B004S7XC05
      *A for RH Side *B for LH Side