TOE CONTROL LINK INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. TEMPORARILY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH

   
   

   1. 

      *a

      Matchmark

      Insert the rear suspension toe adjust cam sub-assembly from the front of the vehicle. Then temporarily tighten the rear No. 2 suspension toe adjust plate and toe control link sub-assembly LH with the nut.

      Note

      Align the matchmarks on the rear suspension toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.

   2. 

      Temporarily tighten the toe control link sub-assembly LH with a new nut.

2. CONNECT SKID CONTROL SENSOR WIRE LH

   
   

   1. 

      Install the skid control sensor wire LH to the toe control link sub-assembly LH with the bolt.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

3. STABILIZE SUSPENSION

   Click here

4. FULLY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH

   
   
   1. 

      *a

      Matchmark

      Fully tighten the nut (rear suspension member sub-assembly side).

      Torque:

      78 N*m  { 795 kgf*cm, 58 ft.*lbf }

      Note

      Align the matchmarks on the rear suspension toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.

   2. Fully tighten the nut (rear axle carrier sub-assembly LH side).

      Torque:

      118 N*m  { 1203 kgf*cm, 87 ft.*lbf }

5. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR

   Click here

6. INSTALL REAR WHEEL

   Click here

7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

   Click here

8. INSPECT AND ADJUST VEHICLE HEIGHT (w/ Air Suspension)

   Click here

9. PERFORM INITIALIZATION

   Parking support brake system	Click here
   Panoramic view monitor system	Click here
   Parking assist monitor system	Click here
   w/o Air Suspension System: Automatic headlight beam level control system	Click here

10. ADJUST HEADLIGHT AIMING

    Click here