PROCEDURE
ADJUST STANDARD VEHICLE HEIGHT
INSPECT VEHICLE HEIGHT
Inspect the vehicle height.
Perform automatic vehicle height adjustment.
The possible vehicle height automatic adjustment value is 25 mm. If the "Height Adjust value + (Standard value - Measurement value - After Height Adjust value)" is 25 mm or more, first perform the standard vehicle height adjustment (height control link adjustment).
ADJUST HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (for Front)
First adjust the height control sensor link that has the highest deviation from the standard value.
If the deviation of the front and rear link is the same, adjust the front link first.
Loosen the 2 lock nuts on the height control sensor link.
Turn the bolt of the height control sensor link to adjust the length.
If raising the vehicle height, lengthen the link.
If lowering the vehicle height, shorten the link.
Turning the bolt of the height control sensor link 1 revolution changes the vehicle height by about 6.9 mm (0.272 in.).
Check if the height control sensor link dimension shown in the illustration is less than the maximum value.
Maximum dimension |
---|
18 mm (0.709 in.) |
Tighten the lock nuts.
5.4 N*m | 55 kgf*cm | 48 in.*lbf |
Make sure the ball joint and bracket are parallel when tightening the lock nuts.
ADJUST HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (for Rear)
*a | Adjustment Range |
Adjust the rear vehicle height by moving the installation position of the link on the lower arm.
5.4 N*m | 55 kgf*cm | 48 in.*lbf |
When the link is moved 1.0 mm (0.0394 in.), the vehicle height is adjusted by about 1.5 mm (0.0591 in.).
Perform vehicle height offset calibration once again.
Inspect the vehicle height once again.
INSPECT WHEEL ALIGNMENT
for Front 2WD:
for Front AWD:
for Rear:
ADJUST HEADLIGHT ASSEMBLY