Click here

TIRE PRESSURE WARNING RECEIVER(for Quarter Pillar) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning receiver removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
Removal and installationof auxiliary batteryterminal Memorize steering angle neutral point LKA/LDA system (for Mono camera type)

for Stereo Camera type:Click here

for Mono Camera type:Click here
Lane control system (for Stereo camera type)
Parking support brake system*
Pre-collision system (for Stereo camera type)
Pre-collision system (for Mono camera type)
Adaptive high beam system

  • Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here
Parking assist monitor system

Click here
Panoramic view monitor system

Click here
Initialize rear door sunshade system Rear door sunshade system

Click here
Initialize power trunk lid system Power trunk lid system

Click here
Tire pressure warning ECU and receiver

  • Register transmitter ID

  • Initialize tire pressure warning system

  • Perform tire position identification

  • When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

  • Tire pressure warning function

for Initialization:Click here

for Registration:Click here
*: When performing learning using the GTS. Click hereClick here
Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. Click here

    REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

    CAUTION:
    B004UM0

    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      Click here

    • If the airbag deploys for any reason, it may cause a serious accident.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. Click here

    REMOVE REAR SEAT ASSEMBLY


    1. for Fixed Seat Type:

      Click here

    2. for Power Seat:

      Click here

  5. Click here

    REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  6. Click here

    REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  7. Click here

    REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

  8. Click here

    REMOVE PACKAGE TRAY TRIM GARNISH LH

    Click here

  9. Click here

    REMOVE PACKAGE TRAY TRIM SIDE COVER LH

    Click here

  10. Click here

    REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  11. Click here

    REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

    Note:

    • Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject itto impact.

    • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with anew one.


    1. B004T43

      Remove the bolt.

    2. Detach the 2 guides and tire pressure warning ECU and receiver.

    3. Disconnect the connector.