QUARTER WINDOW GLASS REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the quarter window glass assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Mono Camera type: Click here for Stereo Camera type: Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Stereo camera type)
		Pre-collision system (for Mono camera type)
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Front seat assembly RH (Only for removal and installation)	Zero point calibration (Occupant classification system)	Occupant classification system Passenger airbag ON/OFF indicator Airbag system (Front passenger side) Seat belt warning system (Front passenger)	Click here

*: When performing learning using the GTS.
Click here

PROCEDURE

PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
1. Disconnect the cable from the negative (-) auxiliary battery terminal.
  
  Click here
  CAUTION:
  
  After disconnecting the cable from the negative (-) auxiliary battery terminal, wait for at least 90 seconds to start the operation.
  
  If the airbag deploys for any reason, it may cause a serious accident.
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

Click here
REMOVE REAR SIDE WINDOW CURTAIN ASSEMBLY LH
1. w/o Rear Quarter Pillar Shade:
  1. Remove the rear side window curtain assembly LH.
    
    Click here
2. w/ Rear Quarter Pillar Shade:
  1. Remove the rear side window curtain assembly LH.
    
    Click here
REMOVE QUARTER WINDOW ASSEMBLY LH
Note
- Be sure to replace the quarter window assembly LH with a new one.
- When separating the quarter window assembly LH, be careful not to damage the paint or interior and exterior ornaments.
1. Protective Tape
  
  Apply protective tape to the area around the installation position of the quarter window assembly LH on the vehicle body to prevent it from being scratched.
2. *a Piano Wire
  
  *b Clip
  
  Pass a piano wire between the vehicle body and quarter window assembly LH from the interior.
3. Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
4. Cut off the adhesive by pulling the piano wire around the quarter window assembly LH.
5. Install the suction cups to the quarter window assembly LH.
6. Using suction cups, detach the clip and remove the quarter window assembly LH.
  Note
  
  Do not to drop the quarter window assembly LH.
  
  Be sure to replace the quarter window assembly LH with a new one.

*a	Piano Wire
*b	Clip