POWER WINDOW REGULATOR MOTOR(for Front Door)

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power window regulator motor assembly removal/installation are shown below.

Table 1. Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative (-) auxiliary battery terminal	Memorize steering angle neutral point	LKA/LDA system (for Mono camera type)	for Mono Camera type:Click here for Stereo Camera type:Click here
		Lane control system (for Stereo camera type)
		Parking support brake system*
		Pre-collision system (for Stereo camera type)
		Pre-collision system (for Mono camera type)
		Adaptive high beam system
		Lighting system (EXT) Cornering lights
		Variable gear ratio steering system	Click here
		Parking assist monitor system	Click here
		Panoramic view monitor system	Click here
	Initialize rear door sunshade system	Rear door sunshade system	Click here
	Initialize power trunk lid system	Power trunk lid system	Click here
Power window regulator motor assembly LH Power window regulator motor assembly RH Front door window regulator assembly LH Front door window regulator assembly RH Front door glass sub-assembly LH Front door glass sub-assembly RH Front door glass run LH Front door glass run RH Front door front glass run LH Front door front glass run RH Front Door No. 2 glass run LH Front Door No. 2 glass run RH	Initialize power window control system	Auto up and down function Jam protection function Catch protection function Remote control function Key-linked function Wireless transmitter-linked function Key-off operation function Window open warning function	Click here

*: When performing learning using the GTS. Click here

Tip:

Use the same procedure as for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

Click here

PROCEDURE

Click here
PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click here

Note:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click here
Click here
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

Click here
Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
1. Disconnect the cable from the negative (-) auxiliary battery terminal.
  
  Click here
  
  CAUTION:
  - After disconnecting the cable from the negative (-) auxiliary battery terminal, wait for at least 90 seconds to start the operation.
  - If the airbag deploys for any reason, it may cause a serious accident.
  Note:
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
Click here
REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH

Click here
Click here
REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
1. Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH from the front door window regulator sub-assembly LH.

POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL