CAUTION / NOTICE / HINT
The following procedure is for the LH side.
Other than areas where instructions are provided, use the same procedure for the LH and RH sides.
PROCEDURE
INSTALL DISC BRAKE AIR GUIDE PLATE
INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
CONNECT STEERING KNUCKLE LH
TEMPORARILY TIGHTEN LOWER NO. 2 SUSPENSION ARM ASSEMBLY LH
TEMPORARILY TIGHTEN FRONT PNEUMATIC CYLINDER WITH SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension)
TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)
CONNECT FRONT STABILIZER LINK ASSEMBLY LH
TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH
CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
CONNECT TIE ROD ASSEMBLY LH
INSTALL FRONT DISC BRAKE DUST COVER LH
INSPECT FRONT AXLE HUB BEARING LOOSENESS
INSPECT FRONT AXLE HUB RUNOUT
INSTALL FRONT DISC LH
for 6-Pot Caliper
except 6-Pot Caliper
CONNECT DISC BRAKE CYLINDER ASSEMBLY
for 6-Pot Caliper
except 6-Pot Caliper
CONNECT FRONT SKID CONTROL SENSOR WIRE
STABILIZE SUSPENSION
FULLY TIGHTEN LOWER NO. 2 SUSPENSION ARM ASSEMBLY LH
FULLY TIGHTEN FRONT LOWER SUSPENSION ARM ASSEMBLY LH
FULLY TIGHTEN FRONT SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)
FULLY TIGHTEN FRONT PNEUMATIC CYLINDER WITH SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension)
INSTALL REAR LOWER ARM MOUNTING REINFORCEMENT SUB-ASSEMBLY LH
INSTALL ENGINE SIDE COVER LH
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
INSTALL FRONT WHEEL
CONNECT BRAKE BOOSTER PUMP CONNECTOR
CHECK FOR SPEED SENSOR SIGNAL
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
INSPECT AND ADJUST VEHICLE HEIGHT (w/ Air Suspension)
PERFORM INITIALIZATION
| Parking support brake system | |
| Panoramic view monitor system | |
| Parking assist monitor system | |
|
ADJUST HEADLIGHT AIMING